Cinque Terre

Hussein M. H. Al-Khafaji

Mechanical Engineering Department

Assistant Professor

This email address is being protected from spambots. You need JavaScript enabled to view it.

"- Educations
1. PhD Applied Mechanics, 2011, Mechanical Engineering Department, University of Technology, Baghdad, Iraq.
2. M.Sc. Applied Mechanics, 1999, Mechanical Engineering Department, University of Technology, Baghdad, Iraq.
3. B.Sc. Aeronautical Engineering, 1995, Mechanical Engineering Department, College of Engineering, University of Baghdad, Iraq.

- I have been working in the Mechanical Department / University of Technology since 2002.
"

Google Scholar Profile

Researcgate Profile

Publons Profile

ORCID iD

scopus

"1. PhD Applied Mechanics, 2011, Mechanical Engineering Department, University of Technology, Baghdad, Iraq.
2. M.Sc. Applied Mechanics, 1999, Mechanical Engineering Department, University of Technology, Baghdad, Iraq .
3. B.Sc. Aeronautical Engineering, 1995, Mechanical Engineering Department, College of Engineering, University of Baghdad k, Iraq.
"

"- Control system
- Smart structures
- Structural health monitoring
- Fault detection
- Thin-walled structures
- Neural networks
- Fuzzy logic
- Design of the experiments"


1-Hussein M. H. Al-Khafaji, “Optimisation of the Lateral Buckling Strength of Corrugated Composite Materials Plate by Neural Networks Method”, accepted in IOP: Materials Science & Engineering, 2019

2-Hussein M. H. Al-Khafaji, “Parameters Optimization for Corrugated Laminated Beam’s Web Under Bucking Load”, Journal of Dijlah, Vol. 1, Issue 2, Spring 2018.

3-Hussein M. H. Al-Khafaji, “ Best Level of Parameters for a Critical Buckling Load for Circular Thin-Walled Structure Subjected to Bending”, Al-Khwarizmi Engineering Journal,Vol. 13, No. 4, P.P. 12- 21 (2017).

4-Hussein M. Al-Khafaji, Muhsin J. Jweeg, “Solving the Inverse Kinematic Equations of Elastic Robot Arm Utilizing Neural Network”, Al-Khwarizmi Engineering Journal, Vol.13, No.1, P.P. 13-25 (2017).

5-Hussein M. Al-Khafaji “Optimum Level Determination of Differentiated Soft Pad Compliance Parameters For Robotic Limbs”, the Iraqi Journal for Mechanical and Materials Engineering, Vol. 16, No. 2, 2016.

6-Hussein M. Al-Khafaji, Muhsin J. Jweeg “Compensating the End-Effector Position of Semi-Flexible Robot Using Smart Structure Technique”, Basrah international conference of mechanical engineering, 2014.

7-Hussein M. Al-Khafaji, Muhsin J. Jweeg, “Kinematic Analysis of Semi-Flexible Robot”, Eng. & Tech. Journal, Vol.30, No.13, 2012.

8-Hussein M. Al-Khafaji, Al-Khafaji Ali J. Dawood, Laith Jaafer Habeeb, “Introduction to Simulation with ANSYS Mechanical APDL”, LAP Lambert Academic Publishing, 2016.

"1. I have been teaching:
- Control systems engineering
- Autopilot

2. I have taught:
- Aircrafts structures for eight years
- mathematics for four years
- mechanical design for three years
- mechanical drawing for three years

3. Give training courses in Hydraulic systems and control, and pneumatic systems and control.
"

blank

Top